and only for the purposes described in this manual. The E5CN, E5CN-U, E5AN, and E5EN are Digital Temperature Controllers. The E5CN and E5CN-U are both . E5CN/E5AN/E5EN Digital Temperature Controllers User’s Manual Basic Temperature Controllers Communications Manual Basic Type (Cat. The free ThermoMini Parameter Copy Software can be used to reach E5CN parameters E5CN Temperature Controller Communications User’s Manual ( Cat.

Author: Akinora Mazurr
Country: Italy
Language: English (Spanish)
Genre: Science
Published (Last): 13 October 2009
Pages: 54
PDF File Size: 13.23 Mb
ePub File Size: 19.64 Mb
ISBN: 533-5-94024-374-8
Downloads: 81489
Price: Free* [*Free Regsitration Required]
Uploader: Turr

The display shows 0 to 20 mA Analog 1, to 9, to numeric Parameter Flow Starting in manual mode. F5cn A Action Control continues, allowing normal operation.


Initial setting level To limit the SP setting The following notation is used. Page Appendix A Action Control continues, allowing normal operation. Page Note Protection cannot be cleared or changed without the password.

Use the U key to set the parameter to The set point limiter is used to prevent the control target from reaching abnormal tem- peratures. This parameter selects the output type for linear current outputs.


Function Transfer type Default Setting a negative value produces an mqnual band. Got it, continue to print.

Page 74 Section Alarm Outputs Set value Alarm type Alarm output operation When alarm value X When alarm value X is positive is negative Lower-limit with standby sequence Absolute-value upper- limit Absolute-value lower-limit Absolute-value upper- limit with standby sequence Absolute-value lower-limit with standby sequence LBA alarm 1 type only Note Adjustment level To limit the manipulated variable sl-h Set point upper limit: Set the maximum permissible change width per unit of time as the SP ramp set value.

Performance data given in this manual is provided as a guide for the user in determining suitability and does not constitute a warranty.

Control stops when you move from the operation level to the initial setting level. Set point upper- sl-h limit 3. Precautions For Operation Foreign particles Install the product in a location that is not subject to liquid or foreign particles entering the product. The password to move to the protect level is entered for this parameter. Upper and lower-limit alarm with standby sequence 6: The MANU indicator will light during manual control.

Mankal temperature controller with segment display pages.


Omron E5CN User Manual

This section describes how to check error codes on the display, and the actions to be taken to remedy the problems. PageScaling upper limit, Scaling lower limit, Decimal point initial setting level: Section Loop Break Alarm 3.

In no event shall the responsibility of OMRON for any act exceed the individual price of the product on which liability is asserted.

Always read and heed the information provided in all safety precautions. Page Section Performing Manual Control Operating Procedure Use the following procedure to set the manipulated variable in manual mode. Input type in-t 2. Refer to the following diagram for CT installation posi- tions.

Calibrating Analog Input analog Input 1,2, Press the U or D key to set the manual MV. Press the U key to set the parameter to 8.

Comments to this Manuals Your Name.